How
to set-up your Raspberry pi:
1.
Begin by slotting your SD card into the SD card slot on the
Raspberry Pi, which will only fit one way.
2.
Next, plug in your USB keyboard and Mouse into the USB slots on
the Raspberry Pi.
3.
Make sure that your monitor or TV is turned on, and that you
have selected the right input (e.g. HDMI 1, DVI, etc)
4.
Then connect your HDMI cable from your Raspberry Pi to your
monitor or TV.
5.
If you intend to connect your Raspberry Pi to the internet, plug
in an Ethernet cable into the Ethernet port next to the USB ports, otherwise
skip this step.
6.
When you are happy that you have plugged in all the cables and
SD card required, finally plug in the micro USB power supply. This action will
turn on and boot your Raspberry Pi.
7. My
MicroSD card is pre-loaded with NOOBS into it. If you don’t have a pre-loaded
MicroSD card then go to www.raspberrypi.org/help/noobs-setup
to set up.
As i stated above I had NOOBS operating system(os) pre-loaded into my SD card but there are different operating systems in https://www.raspberrypi.org/downloads/ which you can try to download but NOOBS is an easy operating system installer compared to the rest.
As i stated above I had NOOBS operating system(os) pre-loaded into my SD card but there are different operating systems in https://www.raspberrypi.org/downloads/ which you can try to download but NOOBS is an easy operating system installer compared to the rest.
No comments:
Post a Comment